Paper Slitter the main components of the system principle

- Jan 31, 2018-

1. Rack and drive system: The rack is composed of left and right wall boards and bracing and discharging machinery.The drive system is mainly used for traction raw materials, winding the finished product, it is powered by variable frequency motor stepless speed V Type with the traction roller operation, the main traction rubber roller and the driven traction roller close contact with the synchronous operation traction material walking, driven by the initiative to pull the roller shaft under the synchronous operation to achieve a better cutting requirements, through the lower round The knife shaft drives winding A and winding B to run synchronously, so as to achieve the purpose of receiving material.

2.Receiving mechanism and tensioning device: The receiving mechanism mainly consists of chain, synchronous wheel, magnetic clutch, and air shaft, etc. By a single motor to control the operation of two reeling shafts, as long as the current of the magnetic particle clutch is adjusted, You can change the receiving shaft tension size.

3. Traction member: The traction member is mainly composed of a pair of traction rubber rollers and several hard-oxidized aluminum rollers, which are used to collect the raw materials for winding the finished products. Its power comes from the motor being transmitted to the active Traction rubber roller to make it work.

4. Slitting knife holder: Slitting knife knife with a round knife cutting, straight knife cutting. Operating the handle through the plane cam can make a small amount of axial movement of the knife to adjust the round knife edge and the cushion groove cut gap.

5. Waste rewinding and discharge: waste through the air duct using blower wind discharge.

6. Discharging mechanism and automatic correction: The discharging mechanism mainly includes discharging shaft, supporting block, cylinder, base, left and right moving seat and so on. It is composed of automatic correcting device: photoelectric head, deflecting guide roller, left and right bracket, Nut and screw, synchronous motor and left and right limit switch.